Quick Start Guide

QUICK START GUIDE

The beauty of using the The HIT device is that the setup time is non-existent!

START WITH YOUR HIT POD

Remove the colored cap and insert into the The HIT device.  Once the HIT POD snaps into the HIT device, the cap effectively becomes a mouthpiece as well as the completing circuit to emit vapor.

LED LIGHT

There is a noticeable LED light ring along the bottom of the HIT device.  The LED light ring will illuminate during use and fade off when it is not being used.

CHARGING PORT

The HIT device uses a micro USB cable connected to its respective micro USB port to recharge.  Simply plug the charging cable into the USB port to recharge the device for up to 1 hour.

When the LED light disappears, it means The HIT is fully charged. Upon removing the charging cable, the LED light will blink three (3) times, indicating a full charge.

Please note: To prevent overcharging The HIT, charging will only work if the device is lower than 75% battery life.